![]() ![]() Solution: If you notice paint bubbles after a primer-free paint application, remove the bubbles using the scraping-and-patching technique outlined below, clean the surface of joint compound dust and other debris, then apply a stain-blocking primer to the surface before re-painting it. Where new paint doesn’t stick to the base coat, it tends to lift off and result in a bubbling top coat. As a result, your base coat of paint will have a thinner binder film than necessary for the next paint coat to stick to. Porous substrates like bare drywall or plaster absorb more of both the pigments and resins (binders) found in the paint than substrates that have been sealed with primer. Let the surface air-dry completely before applying primer and paint to the patched areas. Then, to prevent paint from blistering in the future, thoroughly clean the surface with a sponge dampened with soapy water followed by a dry rag. Solution: You can course-correct using the scraping-and-patching technique outlined in the last section of this article. the bubbles won’t extend down to the substrate. These are examples of those confined to the topcoat, i.e. As the new paint dries and, to some extent, shrinks, it will lift up from soiled areas of the surface and forms unsightly bubbles around specks of grime. With Buddy Tools®, you can finish your drywall project with less effort and topnotch results.Photo: The Painting Surface was DirtyĮver wonder why the first step of painting a room often involves cleaning the wall? Dust, dirt, and grime inevitably collect on interior walls and ceilings over time, and fresh paint has difficulty adhering to surfaces clogged with these loose particles. That’s why TapeBuddy® is preferred by workers of all skill levels – it’s easy to use, easy to clean, and simplifies the job.Ĭontractor-Grade DIY Tools – TapeBuddy® is by Buddy Tools®, part of a trusted high-quality set of drywall tools. Made For DIYers and Professionals – Applying mud compound to dry wall tape does not have to be complicated. TapeBuddy® is your trusted companion for your drywall project and will never let you down. Heavy-Duty and Rust-Free – TapeBuddy® is made with heavy-duty HDPE plastic that will never rust or break easily. Mess-Free and Stress-Free – TapeBuddy® helps ease the stress on your drywall project by applying more compound to the center of the tape, resulting in a perfectly even mud application all throughout. The TapeBuddy® sits steady on a flat surface on top of a 5-gallon bucket using the built-in bottom notches. Product Featuresĭrywall Taping Made Easy – Forget about using a handheld banjo type drywall applicator that will weigh you down and make a mess. Now you can accomplish your drywall project in half the time, with less effort, and excellent results with Buddy Tools®. Simple and easy! You’ll notice a perfectly even amount of compound applied each time – no bubbles or blisters when you apply the tape, less waste, less excess mud, and less sanding.īuddy Tools® contractor-grade tools are preferred by DIYers and professionals. Cut, apply to the seam, smooth and embed. Just load the standard drywall paper tape or FibaFuse, then fill the mud pan with mud compound and pull the tape to your desired length. TapeBuddy® is made with heavy-duty HDPE plastic – which sits steady on a flat surface, and will never rust or break easily. Once you’ve used the TapeBuddy® you’ll never go back to heavy, rusty, and ineffective handheld or banjo drywall tape applicator again! The TapeBuddy® by Buddy Tools® is a simple yet hardworking solution to messy drywall taping. Taping drywall can be easy when you’ve got your Buddy Tools® with you. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |